Diy Pitman Arm Reamer. i need the 1.2 tpf (6 degree) reamer to mod my wagoneer pitman arm. was hoping for some expert advice on if this moog pitman arm will be a good alternative and what i should use to enlarge the hole to make it fit. Along those lines, there are plenty of fab shops that will do this for you. I have taken time off next. does anyone here have the correct taper reamer that they would borrow or rent to me? Its $60 on ebay, but i only need to use it. i have a tapered reamer so i reamed the 76 pitman arm about a 1/4 deeper and installed the tie rods. i am looking to find a pitman arm that i would feel comfortable drilling and reaming out to fit the tie rods i received. I have a tie rod that i need to fit into a pitman arm, the tie rod to pitman stud is too big for the pitman arm.
does anyone here have the correct taper reamer that they would borrow or rent to me? I have taken time off next. was hoping for some expert advice on if this moog pitman arm will be a good alternative and what i should use to enlarge the hole to make it fit. i need the 1.2 tpf (6 degree) reamer to mod my wagoneer pitman arm. i am looking to find a pitman arm that i would feel comfortable drilling and reaming out to fit the tie rods i received. I have a tie rod that i need to fit into a pitman arm, the tie rod to pitman stud is too big for the pitman arm. Along those lines, there are plenty of fab shops that will do this for you. Its $60 on ebay, but i only need to use it. i have a tapered reamer so i reamed the 76 pitman arm about a 1/4 deeper and installed the tie rods.
How To Build a Custom Pitman Arm; Project Gomanche YouTube
Diy Pitman Arm Reamer I have a tie rod that i need to fit into a pitman arm, the tie rod to pitman stud is too big for the pitman arm. i have a tapered reamer so i reamed the 76 pitman arm about a 1/4 deeper and installed the tie rods. I have taken time off next. Its $60 on ebay, but i only need to use it. i need the 1.2 tpf (6 degree) reamer to mod my wagoneer pitman arm. was hoping for some expert advice on if this moog pitman arm will be a good alternative and what i should use to enlarge the hole to make it fit. I have a tie rod that i need to fit into a pitman arm, the tie rod to pitman stud is too big for the pitman arm. does anyone here have the correct taper reamer that they would borrow or rent to me? i am looking to find a pitman arm that i would feel comfortable drilling and reaming out to fit the tie rods i received. Along those lines, there are plenty of fab shops that will do this for you.